Jack from Onsted Michigan writes,
Application time and rate
When is the best time to apply Recommended application rate Specific mixing instructions Thanks JA
The first thing you need to know when using an herbicide such as Drive XLR8 Herbicide is that the exact amount of water you dilute it with is not important. It is only important to make sure you are using the correct amount of product per 1,000 sq ft of lawn. Use too much and you risk damaging your lawn, use too little and you will not get adequate results. You will need to use 0.50 - 1.45 oz per 1,000 sq ft (please read the product label for the exact usage rate needed for your application) . To decide how much water you want to use, you should mark a 1,000 sq ft area, fill your sprayer with water ONLY, and start walking and spraying just as if you were doing the actual application of herbicide. When you are done walking and spraying the 1,000 sq ft area note how much water it took you to spray that area, and that is the amount you will want to mix 0.50 - 1.45 oz of product with for each 1,000 sq ft area that needs to be treated. You will need to make sure treated areas are irrigated with at least 1/2 inch of water (either by rainfall or by sprinkler) following the application. Please contact your local cooperative extension office to determine the correct timing of the application as this will vary greatly from region to region.
Answer last updated on: 10/10/2012