Product Q&A

« See More Q&A's

Chris from Oklahoma writes

Can this be used to spot treat weeds?

I don't want to spray my whole yard but I don't understand how to mix it for spot treatments. Can you help?

Answer:

Yes you can use this product to spot spray being carefull to not overlap heavily. You will need to still mix up the product at the rate for which turf you are treating on as if you were broadcast spreading as this label does not provide a different rate for this specific application. Like most herbicides, there is not a specific amount of Endrun needed per gallon of water. Your goal with herbicides is to get the recommended amount of product over the area to be treated. In this case the product label says you should use 1.8 pints - 4.0 pints of Endrun per acre (the actual amount you use will depend on the grasses you are treating) using 5-75 gallons of water. The actual amount of water you use is not very important as water is just the carrier. It is very important to make sure you are applying the correct amount of product over the area to be treated. Some grasses are more sensitive than others and the Endrun product label does give special instructions for those grasses so we do recommend that you read the product label completely before using the product.

Answer last updated on: 08/04/2013

Was this answer helpful to you? Yes No

5 of 9 people found this answer helpful.

EndRun Herbicide with Trimec

EndRun Herbicide with Trimec

4.5 out of 5 stars

$78.11

Free Shipping*