Displaying 1 to 6 (of 6 reviews)
3 of 3 people found this review helpful:
Fast out worked the first time.
By Mike on 09/02/2010
Had yellow jackets in my wall. Drilled one little hole and sprayed the foam in. The yellow jackets did not fly off they entered the nest and the product did the work. The other sprays I tried repelled them temporarily and they continued to return to the nest in time.
1 of 1 people found this review helpful:
By Damian on 09/28/2012
I have a wasp nest inside my outer wall. The wasps are getting in where the upper vinyl siding meets the lower brick. I hung 3 bag traps that catch 10-20/day each but not enough to make a real difference. I tried wasp "foaming" spray, but they just disperse as soon as you spray, then fly back to the crack. I even sprayed it into the cracks and it didn't do anything. It doesn't really foam up like you expect, and it dissolves instantly. I read that wasps do not like the scent of dryer sheets and will abandon the nest - wrong! I stuffed them in the crack and they did exit at first, but soon came back. I also took rat glue traps(glue is nice and thick so they sink into it), taped them back to back to the end of a pole, leaned it against the main entrance and within 5 minutes each was covered in 40 wasps. That does seem to be pretty fast and effective, but still doesn't eliminate them. So after all these attempts I came across this CS Foam and thought I'd try it. I zip tied a metal rod to the plastic tubing so I could jam it 3-4 inches under the siding. It foams up like crazy. Similar to insulation foam, but not as dense and thick. More like a light shaving cream foam. The foam lasts several hours. I stuck it into 3 mortar joints and sprayed 4-5 seconds until it spewed out. The 1st time was later in the evening and most had already returned to the nest, so it didn't do much as by morning when they venture out the foam was gone, although the bag traps had much fewer wasps. The next day I did it earlier when they were still active and soon there were a lot buzzing around trying to get in the cracks. Some landed on the foam and got stuck, but didn't kill them instantly. I used my rat glue board trap on a pole and left it at the main entrance for an hour thinking they will land on it trying to get in. When I came back it had 50 wasps plus a queen. Not sure if it is THE queen or a young queen. Either way I was happily surprised. I'll see tonite if there are more, but I doubt it, as I captured a queen. There is no nasty smell. The only thing is it would be nice if the foam had an attractant that lured them to land on the foam which makes them stuck, otherwise it works great.
1 of 1 people found this review helpful:
FastOut CS Foam - 20 oz Lives Up To Its Name
By on 08/24/2013
After getting invaded by termites in our summer cabin we needed immediate help. After searching the internet we decided on the FastOut CS Foam - 20 oz pressurized spray bottle. After removing a wall panel and spraying the area and also the area where house electrical wiring comes up through the floor to the service panel. I also drilled 1/8" holes, sprayed and plugged to get at other areas in this small section of our cabin that was infected. Within two days there was no noise of gnawing or signs of sawdust. I then continued with the Dominion 2L Termicide Concentrate treatment by digging a trench, adding four gallons every four feet and then spraying the back-fill and spraying the lower three feet of the walls and foundation sides. After a couple of weeks there is no indication of termite activity. Now we will see how long this control procedure will last. So far so good!
Got Rid of Termites Fast!!
By Willard on 03/07/2012
I ordered FastOut CS Foam and followed the directions and the termites are gone!! The results are just as good as the company I paid $600.00 to apply their product in the same way. I will order more to do spot treatment when I return to Florida this fall. Thanks again for a product that does as advertised!!
By J.m.l. on 05/07/2012
The product came damaged. I sent an e-mail to the vendor who replied immediately and replaced the product within two days.
By Harry on 06/04/2012
The applicator nozzle is too short when using from inside on outside walls that have a vapor barrier. The foam just fills between the backside of the inside wall and vapor barrier. I had to buy 1/8" ID PFE tubing, jam it on over the slightly larger plastic tip on the nozzle and use it as an extender... but not until after wasting one can. The extender still fell off once in a while, making a mess, not to mention the larger hole needed for the extender. It might be a good product if you could get into the necessary area effectively.