Product Q&A

Answer:

When applying Termidor Dry, the openings should be approximately every 24" or into each void. The tip of the Termidor Dry is only about 1/8 of an inch in size and the hole the product comes out of on the tip is even smaller. However, no matter how small the tip is you must drill into the holes to ensure the product penetrates into the galleries for full treatment reach. Large holes are not necessary but using a small drill bit for a pilot hole would be needed. 

Answer last updated on: 05/08/2016

Was this answer helpful to you? Yes No

2 of 2 people found this answer helpful.