Mixing too much of an insecticide like Talstar P (Talstar One) is never recommended. Over-application can make an area more repellent, causing insects to avoid it so that the product cannot do its job.
Talstar P (Talstar One) should be applied in the morning or evening especially during the summer. You really just need to focus on the tree line. Spray the undersides of leaves on the trees and shrubs. Focus on debris piles like leaf piles, pinestraw and shaded moist areas. Please see our Mosquito Pest Guide for more information about treating for mosquitoes.
We recommend using 1 fl oz of Talstar P per gallon of water. Use 2 gallons of solution/1000 square feet, immediate irrigation of treated area with at least 0.25 inches of water following application to ensure efficacy of sub-surface pests such as,
but not limited to, Mole Crickets, is recommended.
Mole Cricket adults: Achieving acceptable control of adult mole crickets is difficult because preferred grass areas are subject to continuous invasion during the early spring by this extremely active stage. Applications should be made as late in the day as possible and should be watered in with up to 0.25 inches of water immediately after treatment. If the soil is not moist, then it is important to irrigate
before application to bring the mole crickets closer to the soil surface where contact with the insecticide will be maximized. Grass areas that receive pressure from adult mole crickets should be treated at peak egg hatch to ensure optimum control of subsequent nymph populations (see below).
Mole Cricket nymphs: Grass areas that received intense adult mole cricket pressure in the spring should be treated immediately prior to peak egg hatch. Optimal control is achieved at this time because young nymphs are more susceptible to insecticides and they are located near the soil surface where the insecticide is most concentrated. Control of larger, more damaging, nymphs later in the
year may require both higher application rates and more frequent applications to maintain acceptable control. Applications should be made as late in the day as possible and should be watered in with up to 0.25 inches of water immediately after treatment. If the soil is not moist, then it is important to irrigate before application to bring the mole crickets closer to the soil surface where contact with the insecticide will be maximized.
Talstar P Professional Insecticide can safely be applied in and around homes with pets as long as it is used according to the product label. Please make sure your dog is out of the area during treatment until the product has had time to dry completely. At that time your pet can resume normal activity.
For best results, Talstar P should be applied when temperatures are between 40-85 degrees F. If your temps are higher than that during the day, apply in the early morning or evening.
You can help prevent these flies from entering your home by spraying a barrier application of Talstar P paying special attention to window frames, window screens, door frames, and cracks and crevices that may be used as points of entry. A screen with a very fine mesh (smaller than 16mesh) will help prevent entry. Additionally it may be helpful to keep ceiling fans and window fans on at high speeds to keep insects out of small areas.
If flies have already entered your home and you need immediate control use Microcare. This product offers a fast knockdown and kill of flying insects, giving you immediate relief.