Roach Gel and Bait Station Placement Guide

Following is a general room-by-room placement guide for Maxforce Roach Bait Stations (Exact placement should be based on a complete monitoring and inspection):

Kitchen FC Bait Station Placements

* Refrigerator: Between refrigerator and nearby appliance, such as the dishwasher
* Sink: Alongside pipe collar where drainpipe enters the wall
* Cupboards: Flush mounted against an upper corner
* Other appliances: Behind microwave, toaster, blender, coffee maker, etc.
* Floor placements: underneath dishwasher and/or oven

Kichen Gel Placements

* Drawers: Alongside the interior of the door frame
* Cupboards: Underneath selected cupboards where frame meets wall
* Counter: Underneath counter where sink is located
* Fume Hood: Along the inside rear corner of hood (ensure no gel will drip onto stove top)

Bathroom Bait Station Placements

* Toilet: Mounted on upper rear corner of tank
* Lower Cabinets: Flush mounted against an upper corner
* Sink: Alongside pipe collar where drainpipe enters the wall

Bathroom Gel Placements

* Sink: Upward angle into the overflow drain
* Condensation Surfaces: Places where condensation can build up such as the tops of doorframes and medicine cabinets, and alongside decorations

Other Rooms (Indoors) Bait Station Placements

* Closets: Flush mounted against an upper corner
* Appliances: Behind the television, stereo, computer monitor, fish tank, wall clocks, light fixtures, etc.
* Dressers: Flush mounted in corner alongside the interior of the drawer frame
* Furniture: Under base of couch and/or bed where crumbs accumulate
* Utility Room/Area: Underneath hot water heater and/or adjacent to washing machine
* Garage: Flush mounted to door frame where roaches can enter residence

Other Room Gel Placements

* Interior piping: Around all exposed interior pipe channels (such as hot water heater inlet)

Outdoors Gel Placements

* Rain Gutters: Apply in seam between rain gutters and roof
* Attic & Soffit Vents: Between air vent holes
* Siding: Under siding/molding
* Exposed pipes: Around all exterior pipe collars or where pipe enters wall
* Also: In brick weep holes, in window cracks and crevices, around decks and stairs, around the intake vents of air conditioning units