Surflan Pro Herbicide (Oryzalin 40.4%) - Questions & Answers

Displaying 1 to 20 (of 87 questions)
Sort:
  • Asked by Tony from Ohio
    09/19/2011
    Q
    How many ounces of Surflan do I need to use per gal of water?
    I have evergreen trees planted in rows. How many ounces of Surflan do I need per gallon to control weeds for 4 months? Cultivation of soil around trees is not possible. Will this product still work?
    A
    Surflan Pro is a pre-emergent weed control product. Surflan Pro does not control emerged weeds, established weeds, weeds growing from stolens, rhizomes, or root pieces. The area to be treated with this product needs to be weed free at the time of the application. You will need to use 3 fl oz of product per 1-2 gallons of water for 1,000 sq ft. The water in this case is just a carrier and you need to use enough water to make sure you get even coverage and to make sure you are getting the correct amount of product over the 1,000 sq ft area. There are directions on page 7 of the Surflan Pro product label that explains how to properly calibrate your sprayer.
    Was this answer helpful to you?   Yes No
    101 of 114 people found this answer helpful.
  • Asked by Lynn
    07/10/2011
    Q
    What is the difference between Surflan AS and Surflan Pro?
    A
    There is no difference between the two.  Surflan AS and Surflan Pro are the same product.  The manufacturer, for whatever reason, call them different things to differentiate between the product sizes, but they are the same product.
    Was this answer helpful to you?   Yes No
    72 of 73 people found this answer helpful.
  • Asked by Laurence from Tucson, Az
    09/16/2016
    Q
    What is a good pre-emergent to use in Tucson, AZ on a rock area?
    Please advise as to how to apply. Can I apply with a hose end sprayer? Will it harm cactus, mesquite trees and other desert landscaping?
    A

    Surflan is often used for this type of weed control with great results depending on the type of weeds you are trying to prevent. You will need about 3 fl oz of Surflan per 1,000 sq ft area. Be sure you review the product label to make sure your desirable plants are listed as being tolerant to the product.  Surflan products are known to be pretty thick and will likely clog a hose end sprayer so it is best to apply with a pump or backpack sprayer. The other problem with using the hose end sprayer for the Surflan application is that they are not very accurate and you can wind up dispensing more/less product than needed in a given area which can lead to less than desirable results.  With pre-emergents it is important to apply the right amount of product over an area and water in so that it gets down to the soil to create the barrier.

    Was this answer helpful to you?   Yes No
    48 of 58 people found this answer helpful.
  • Asked by Lonnie from Okc Ok
    05/02/2012
    Q
    What is the shelf life of Surflan Pro Herbicide?
    A
    You should use the Surflan Pro Herbicide within 3 years of the date of purchase.
    Was this answer helpful to you?   Yes No
    30 of 31 people found this answer helpful.
  • Asked by Ed from Bakersfield Ca
    09/06/2011
    Q
    Is Surflan Pro a good choice for bare ground to prevent spring weeds and foxtails?
    A
    Surflan Pro is a great product for treatment of bare ground but when applying it to bare ground it should be applied at a higher rate of concentration, which would be 4 quarts per acre.
    Was this answer helpful to you?   Yes No
    23 of 23 people found this answer helpful.
  • Asked by Richard from Marlborough, Mass.
    09/25/2011
    Q
    Does Surflan Pro control crabgrass?
    I have a lot of crabgrass on my lawn. Can I use this product next spring to keep the crabgrass from growing?
    A
    Surflan Pro is labeled to control crabgrass in your turf and is a great product to use as a pre-emergent.  You should apply pre-emergents now in the fall, and then again in the spring typically.  For optimum times in your area to apply a pre-emergent, you should contact your local county extension office.
    Was this answer helpful to you?   Yes No
    20 of 20 people found this answer helpful.
  • Asked by Brian from Morrilton Ar
    08/18/2014
    Q
    How do you mix Surflan Pro Herbicide? How many ounces per gallon?
    A
    Surflan Pro Herbicide application you will need to use 3 fl oz of product per 1-2 gallons of water for 1,000 sq ft. The water in this case is just a carrier and you need to use enough water to make sure you get even coverage and to make sure you are getting the correct amount of product over the 1,000 sq ft area. There are directions on page 7 of the Surflan Pro product label that explains how to properly calibrate your sprayer.
    Was this answer helpful to you?   Yes No
    14 of 17 people found this answer helpful.
  • Asked by Keith from Pompano Beach
    12/12/2013
    Q
    Is the Orange color in Surflan Pro Herbicide staining?
    Like several other people I have a lot of stone in my Florida landscaping. Most of the rock is Medium White or Brown. Will the Orange color of Surflan Pro stain the whiter rocks or will rain wash it off over time??
    A
    Surflan Pro may cause a slight stain.  If you start to notice a slight discolor, rinsing the rocks with water should remove it.
    Was this answer helpful to you?   Yes No
    14 of 15 people found this answer helpful.
  • Asked by Kelli from Cincinnati, Oh
    04/02/2016
    Q
    Once dry, is it safe for pets to be on the areas treated with Surflan Pro?
    To be used in a backyard with dogs.
    A

    Pets should be out of the area during treatment with Surflan Pro until the area dries. Typically a few hours is best.  Once dry it is safe for pets to return to the area.

    Was this answer helpful to you?   Yes No
    11 of 13 people found this answer helpful.
  • Asked by Gary from Wagoner Ok
    03/29/2015
    Q
    How soon can you mow after spraying Surflan?
    A
    We would recommend waiting at least 2-3 days after applying Surflan in order to mow your lawn. This goes for before an application as well.
    Was this answer helpful to you?   Yes No
    11 of 12 people found this answer helpful.
  • Asked by Maxine
    04/20/2016
    Q
    Is Surflan Pro Herbicide safe for use on St. Augustine grass to kill southern sandburs?
    A

    Surflan Pro Herbicide can be applied to well established St. Augustine lawns and it is labeled for sandburs. Please refer to the product label for full mixing and application instructions. This product is a pre-emergent so it will prevent, not kill existing weeds.

    Was this answer helpful to you?   Yes No
    11 of 11 people found this answer helpful.
  • Asked by Jeremiah from Ham Lake Mn
    07/01/2013
    Q
    Can I mix Surflan Pro with Anime 400?
    Anime 400 is Dimethylamine salt of 2,4-dichlorophenoxyacetic acid - 46.47%. I purchased your Surflan pro. I would prefer using Glyphosate but I have a bunch of 2,4-D on hand already. I am looking to knock out broadleafs and prevent emergence as well.
    A
    The blend of Surflan Pro and Anime 400 would be a great mix to use for control of the broad leaf weeds. Make sure to not water it in for at least 24 hours and you will see great results. Please let us know if you have any other questions.
    Was this answer helpful to you?   Yes No
    8 of 9 people found this answer helpful.
  • Asked by Mike from Mustang, Ok
    02/16/2014
    Q
    I have a small yard, about 5500 sq. feet what is the best way to spray it?
    I read that hose end sprayers will likely clog due to the thickness of the product.
    A
    Using a pressurized hand-pump sprayer would work well. You can find them in 1 or 2 gallon sizes. 1 gallon generally covers about 1,000 sq ft.
    Was this answer helpful to you?   Yes No
    8 of 10 people found this answer helpful.
  • Asked by Sam from Yakima
    05/19/2014
    Q
    Can you use Surflan Pro on strawberries, raspberries and blackberries?
    A
    Surflan Pro is a pre-emergent herbicide that should be applied to turfgrasses and nothing edible.
    Was this answer helpful to you?   Yes No
    8 of 11 people found this answer helpful.
  • Asked by Leonard from Car Coral, Florida
    03/03/2016
    Q
    What herbicides can I use that will not kill my ground cover?
    I have ground cover. Weed removal is tedious.
    A

    Depending on the type of weeds you have in your ground cover and the type of ground cover you have will depend on what product options may work for you. Without more specifics we cannot say for certain that the following products will get rid of what you have and will not harm your ground cover. You will want to check the product labels to ensure they meet your needs. 

    For post emergent control (killing something that has already come up in your treatment areas) if the weeds are grassy you could use something like Grass Out Max or Fertilome Over the Top. This will only kill and target grasses coming up in ornamental beds. If you have broadleaf weeds, hand pulling or spot treating with roundup for post emergent control is about the only option. Broadleaf weed control products cannot be sprayed over the top of ground covers as they are broadleaf plants and will likely be harmed as well. 

    For pre emergent control (preventing weeds/grasses from coming up through treatment areas) you have a lot more options to choose from. Surflan Pro/Surflan AS, Gallery 75 DF, Snapshot and many others would be wonderful options that you can use in spring and fall to help prevent persistant weeds from coming back throughout the season. 

    Again, please check the product labels on each page to ensure that the weeds you are targeting and the ground cover you have are on the label as safe for use. 

    Was this answer helpful to you?   Yes No
    7 of 12 people found this answer helpful.
  • Asked by Gary from Sahuarita,az.
    04/10/2016
    Q
    At what temperature range should Surflan pro be stored?
    A

    Be sure to store Surflan Pro in a cool dry area. Ideally, temps would be best above freezing and below 95 degrees.

    Was this answer helpful to you?   Yes No
    7 of 8 people found this answer helpful.
  • Asked by Tom from Blue Ridge, Ga
    02/17/2016
    Q
    I have a moss lawn in the mountains of North Georgia. Will Surflan harm my moss?
    A

    Surflan Pro Herbicide is a pre emergent herbicide that will prevent weeds and grasses from germinating.  If it is applied to a moss lawn, it will prevent new weeds, including new moss, from emerging.  It will not hurt moss that has already germinated.

    Was this answer helpful to you?   Yes No
    6 of 6 people found this answer helpful.
  • Asked by Hitesh from Canton,texas
    02/06/2013
    Q
    Can I use Surflan with a dial up hose sprayer like ortho's?
    A
    Surflan products are known to be pretty thick and will likely clog the hose end sprayer. The other problem with using the hose end sprayer for the Surflan application is that they are not very accurate and you can wind up dispensing more/less product than needed in a given area which can lead to less than desirable results.
    Was this answer helpful to you?   Yes No
    6 of 10 people found this answer helpful.
  • Asked by Rod from Ocala, Fla
    02/03/2018
    Q
    Can Surflan Pro Herbicide be used on Centipede and St. Augustine grass?
    A

    Yes, Surflan Pro Herbicide can safely be applied to established Centipede and St. Augustine grass. 

    Was this answer helpful to you?   Yes No
    4 of 4 people found this answer helpful.
  • Asked by Paul from Bethesda, Md
    10/09/2015
    Q
    Can Surflan Pro Herbicide be used over pachysandra and periwinkle?
    We would also like to know if it can be used over ground covers, geranium, echinasia, roses, daylillies and sedum.
    A

    Surflan Pro Herbicide can be used over pachysandra, periwinkle, various ground covers, geraniums, echinasia, daylillies and sedum. This product cannot be used over roses.

    Was this answer helpful to you?   Yes No
    3 of 3 people found this answer helpful.
Displaying 1 to 20 (of 87 questions)