Product Label MSDS
4 THE BIRDS is a transparent, sticky product that remains tacky after the initial application has set. This product may be applied inside onto beams, girders, struts, supports, and other places where birds can sit and roost or outdoors on trees, bushes and vines. (Do not apply to the exterior of buildings or structures). APPLICATION DIRECTIONS: Surface Preparation: Clean surfaces to be treated to promote adhesion of repellent. Wipe or scrape all dust, dirt, droppings, and other loose debris from surfaces. Seal porous surfaces prior to treatment by brushing on one coat, shellac or a 50% solution of white glue, and allow to dry. Product Application: FOR INTERIOR USE: Beams, girders, struts, supports, and other places where birds can sit and roost. - Prior to application, cover machinery, floors, and other important items and surfaces to prevent product from falling on them.
- Do not dilute 4 The Birds Liquid with water or other solvents. Use as is.
- Spray to the point of runoff. Spray in such a way that the top surfaces of beams, girders, etc. are coated. This would necessitate the operator to be level with or above the surfaces during application. Apply with any hand or pressure spray gun which has a discharge pressure of more than 40 and less than 150 p.s.i.
- Apply product using a paint brush to surfaces that are difficult to cover by spraying.
FOR EXTERIOR USE: Trees, bushes and vines. (Do not apply to the exterior of buildings or structures). - Prior to application, cover walkways and other surfaces that should be kept clean of repellent which might fall on them.
- Apply 4 The Birds Liquid to the point of runoff to the top sides of all branches in the plants to be treated that are large enough to support a bird.
- Do not dilute 4 The Birds Liquid with water or other solvents. Use as is.
- Applications can only be made with hand or pressure spray guns which can generate sufficient pressure, up to 150 p.s.i., to move the material to the desired treatment site. Keep material agitated. Do not apply this product from aircraft.
- It is recommended that treatment to trees, bushes, and shrubs be made in the fall or early spring when limbs are bare and easily accessible. When used as directed, 4 The Birds Liquid will neither harm trees and other vegetation nor cause phytotoxicity to foliage.
- Spraying should be done when temperatures are 40o F or above. Drift can be minimized or eliminated by applying during calm conditions.
- The amount of coverage you can expect is dependent on type of tree, bush or shrub you are treating, spray equipment, and number of and size of branches treated. Generally, one gallon of 4 The Birds Liquid is sufficient to treat an average tree with a 5" diameter trunk, after foliage has fallen, or approximately six (6) three-foot high shrubs. These coverage approximations should be used only as a guideline.
Product Clean-up: Repellent can be removed from interior surfaces, such as metal beams, wood, laminates and painted surfaces, with mineral spirits. Repellent can be removed from sealed concrete, tile or stone surfaces by hosing with water if this is done within a very short time after the area was coated. Application equipment should be cleaned with mineral spirits after each use. CAUTION: Do not apply repellent to trees, bushes, and vines that are in bloom or bearing fruit. ***NOTE: Do not spray directly on birds. Do not apply at locations where the user has concern that desirable birds may become entangled in the repellent.*** |