Product Q&A

Answer:

Herbicides are a lot different than other concentrated products and can be hard to understand at first. The application rate depends on the the type of turf you have and how quickly you apply the product.  You will need to read the product label to determine the correct usage rate for your needs (you did not give us any information about the type of lawn, region or application program you will be using so we cannot give you exact rates). The amount of water used to apply Blindside Herbicide is not critical, but should be sufficient for uniform coverage of the target area. Calibrate by determining the volume of water required to treat 1,000 square feet. Use this calibration volume to determine the amount of water and Blindside needed to treat the target area (see the following calibration example). Note: Sprayer calibration (volume of spray needed to treat 1,000 square feet) will vary with each individual operator. Steps in Calibration: 1. Mark an area of 1,000 square feet (i.e. 20 by 50 feet or 25 by 40 feet). 2. Place the sprayer on a level surface and add water noting the final level of water in the spray tank. 3. Spray the marked area with a sufficient volume of water to provide uniform coverage. Refill the sprayer to the same level as before measuring the amount of water added. The measured water added to the sprayer is the volume needed to cover 1,000 square feet. The amount of Blindside Herbicide WDG per 1,000 sq ft: Cool Season grasses: 0.075 - 0.15 per 1,000 sq. ft. (3.25 - 6.5 oz. per acre) Warm Season grasses (St. Augustine): 0.15 - 0.23 per 1,000 sq. ft. (6.5 - 10 oz. per acre) 

Answer last updated on: 05/06/2016

Was this answer helpful to you? Yes No

19 of 83 people found this answer helpful.