Product Q&A

« See More Q&A's

Christopher from Fort Mill, Sc writes

Can I use the Bonide Hose End Auto Mix to apply a postemergent herbicide such as Surge?

I want to apply Surge Broadleaf Herbicide for Turf to my lawn.

Answer:

Surge Broadleaf Herbicide is not recommended to be used in a hose end sprayer. The first thing you need to know when using an herbicide such as Surge Broadleaf Herbicide is that the exact amount of water you dilute it with is not important. It is only important to make sure you are using the correct amount of product per 1,000 sq ft of lawn. Use too much and you risk damaging your lawn, use too little and you will not get adequate results. To decide how much water you want to use, you should mark a 1,000 sq ft area, fill your sprayer with water ONLY, and start walking and spraying just as if you were doing the actual application of herbicide. When you are done walking and spraying the 1,000 sq ft area note how much water it took you to spray that area, and that is the amount you will want to mix the product with for each 1,000 sq ft area that needs to be treated. You will need to make sure treated areas are irrigated with at least 1/2 inch of water (either by rainfall or by sprinkler) following the application. The mixing ratio all depends depends on what you are treating for and what type of turf you are applying too. Please refer to the product label for the amount of product needed for your application.

Answer last updated on: 06/06/2016

Was this answer helpful to you? Yes No

1 of 1 people found this answer helpful.

Bonide Hose End Auto Mix

Bonide Hose End Auto Mix

3 out of 5 stars

$35.98

Free Shipping*