Product Q&A

« See More Q&A's

Barney writes

How should I use Mold Clean in my crawl space?

I have mold in a crawl space. I plan to use Bora-Care with Mold-Care to kill it but would like to use Mold-Clean to remove the black stains. The directions state that you should rinse the Mold-Care with a high pressure stream. That is not feasible in a crawl space or attic. Any suggestions?

Answer:

For best results the label for Mold-Clean recommends using a high pressure stream but you are right, it is not feasible to do this in a crawl space or attic space.  We would recommend wetting the stained area with water, then spray the Mold-Clean on the area and let sit for 10 minutes.  Do not allow the product to dry, keep wet with water in a spray bottle if necessary.  Then after the Mold-Clean has sat on the wood for 10 minutes, take a scrub brush and a bucket of water and scrub the stained area using a liberal amount of water.  This should help get the wood pretty close to the same effect of using a high pressure stream.

Answer last updated on: 04/27/2010

Was this answer helpful to you? Yes No

11 of 12 people found this answer helpful.

Mold-Clean

Mold-Clean

2.5 out of 5 stars

$37.19

Free Shipping*