• Please Note: If you have questions about an order you placed, shipping policies, product availability or product returns, please do not use this form. Direct these questions to our customer support center or by calling 866-581-7378.

    Most product questions are answered within 24 hours.
    Not all questions and answers will appear on our website. Thank you for choosing DoMyOwn.com!
  •  
  • * (limit 110 characters)
  • (optional)
  • *
  • *
  •   (city, state)
  •     Cancel

Q&A Home

Nr from Albany, Ny writes,
06/25/2017:

What would be the recommended setting using a Scotts Broadcast Spreader to apply Niban Granular Bait?

Answer:

The Niban Granular Baitlabel calls for 6 ounces per 100 sq ft, / 4 lbs. per†1000 square feet.† If your spreader settings go from 1 to 10 (1 letting out the least and 10 letting out the most) you typically want to be around a 4 setting.† If your spreader goes from 1 to 20, you should probably be around a 7 or 8 setting.† The goal is to just run out of product when you are done walking the 1000 square feet.† One person may walk faster than someone else, so they may place It on a higher setting than someone that walks slower.†

Almost all fertilizers, herbicides, insecticides, etc have treatments in amounts of so much product per 1000 square feet.† So if you can figure out what your walking speed is then you know anytime you apply any product that calls for so much of it per 1000 square feet, you always set your spreader on this setting.† You can calibrate this by marking off a 1000 square foot (10 x 100) area and placing 4 lbs†of the Niban Granular Bait in the spreader.† Start with a low setting and start walking your marked off area at a normal pace.† You can adjust as you go and find the basic setting for you to apply the product over a 1000 square feet.†

Answer last updated on: 06/25/2017

Was this answer helpful to you? Yes No